(IS:4984-1995 & IS: 14333-1996)
MATERIALS
HDPE Pipes is made of either of
three grades of High Density Poly Ethylene polymers. i.e PE-63, PE-80 or
PE-100.
PRODUCT RANGE
These HDPE pipes are
available in sizes 20mm to 315mm in pressure rating of PN-2.5, PN-4.0,
PN6.0, PN8.0, PN-10.0, PN 12.5 & PN-16.0 in all three grades PE-63,
PE-80 and PE-100.
APPLICATIONS
- Effluent and waste water Disposal:
Effluents of varied chemical compositions can be effectively disposed of
using Tijaria/Vikas HDPE
pipes & coil, with aid of the latest know-how on piping
engineering, pipelines for waste collection and disposal in chemical
industry. Longevity of
Tijaria/Vikas HDPE pipes under such application would rate the best
amongst the conventional HDPE pipe even under critical service
conditions.
- Domestic Gas Distributions:
Earlier, engineers always carried a psychological fear in using
HDPE pipes rather plastic pipes for conveyance of inflammably
gases. However experiments and extensive trials proved these fears
totally wrong and have established excellence of performance of
HDPE pipes for conveyance of all type of combustible gases.
Experiments have also proved that the permeable losses are insignificant
in regard to safety and environmental impact.
|
- Submarine Pipelines:
One of the most important applications where all salient features of
Vikas HDPE pipes prominently figure out is for under water pipelines.
Tijaria HDPE pipes have been successfully laid for under water river
crossing, creek crossing, marine out-falls and for brine intake lines in the
open sea. Hazardous chemical effluents and radio active wastes are being
harmlessly disposed into deep sea through
Tijaria./Vikas HDPE pipes with substantial cost savings. Schemes which
would have been dropped due to economical un-viability have been made feasible
with
Tijaria / Vikas HDPE pipes. |
 |
ADVANTAGES
- HDPE pipe is economical than traditional pipe material.
- Resistance to chemicals - Exceptional resistance to all
external and internal corrosion.
-
HDPE pipe will not rust or rot.
-
Welded joints speedup installation -Trench width reduced which leads to
saving in the cost of excavation and back filling.
- Light weight - One sixth of the weight of steel. Low
specific gravity giving an outstanding light weight product for easy
transportation, handling, fitting etc.
-
Very good thermal insulation due to low thermal conductivity.
-
Smooth bore provided less head loss. Flow resistance is approximately 30% less
than that of conventional pipes, permitting the use of a smaller bore pipe for a
given rate of flow.
-
Perfect stability of material obviates the risk of ageing.
-
Total neutrality to products conveyed.
- Flame resistance classifying the material as self extinguishing
according to test standard employed.
-
Low maintenance cost.
-
Easy to install.
-
Longer life than G.I, M.S cement and other pipes.
